Please follow the instructions provided below add to the corresponding load definitions.
Table1: Surface
| 1 | Navigate to Load Geometry Definitions > Surface > Quadrilateral |  |
| 2 | Click three-dots icon on Bridge cell and set “Bridge1”. | |
| 3 | Set the name as Span1DeckSurface Enter Start Station, End Station and Surface Width data as in the figure for Span1DeckSurface (Load Surface Definitions). |  |
| 4 | Keep the default data in the Graphics section constant. |  |
| 5 | As there are 3 spans in the project, it is necessary to define 3 different surface loads.
|  |
Follow the below steps to copy and paste all inputs from our data set.
| 1 | Go to Quadrilateral under Load Geometry Definitions on the tree view. |
| 2 | Copy Surface, and Graphics from model inputs and paste into OpenBrIM. |
0 Comments