Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 12 Next »

In OpenBrIM, "support lines" is the term used to describe the locations of abutments and piers in plan view. These lines are typically placed at the centerline of piers and the front face of backwalls for abutments, and are also used to determine the extents of the deck and beams.

Bridge Parameters

It is necessary to create a single support line for each abutment and pier location.

Bridge: Assign the bridge to the support line.

Station: Specify the station of the support line.

Skew Angle: Define the skew angle of the support line. See below screenshot for positive and negative skew.

Transverse Offset: Specify the transverse offset to move the support line center from PGL (projected grade line).

3D Visual

Support Line Width: It is used to determine the width of the support line

Show/Hide: This parameter is used to toggle the object in 3D view.

Label: This parameter can be used to change the name of the object in 3D view.

  • No labels