Prestressed I Girder Code Check [EX1-PIG]

Please follow the instructions provided below to create Prestressed I Girder Code Check

1	In this section, you can specify the precast I girders you wish to analyze, along with their strength losses and the relevant code requirements you want to consider for this analysis. This information is essential for conducting code checks.
2	Navigate Superstructure Code Checks > Prestressed I Girder Code Check
3	Click three-dots icon on Girder and click select Set as G2 and G12 girders 2 Girders were selected from 2 different spans. Code control will be made when one of the girder is in the middle of the distance and the other girder is close distance to the support.
4	Click three-dots icon on Code Check Template and assing PIGTemp both of them
5	Click three-dots icon on Detailed Calculation Position and click select.
6	Assign data as follows for PIG2 : 0.5L for PIG12 : 0.9L
7	Keep "Number of Code Check Location" parameter constant as defult value.
8	Navigate Loss Calculation Tab
9	Enter parameter values as in the figure
10	Navigate Shear Reinforcement tab.
11	Click three-dots icon on Shear Reinforcement data for PIGCC1 (PIG2) and click select.
12	In this section, we will establish the calculation for shear reinforcement compaction in a manner that is specific to each station. This will be done within the spreadsheet.
13