Please follow the instructions provided below to add the insertion points where the bearings will be created.
| 1 | Navigate to Bridge Geometry > Insertion Point |  |
| 2 | To create the first insertion point, click on the three-dot icon located on the first cell of the Location and set its location to "Abut1". | |
| 3 | For each support line, there should be one insertion point positioned beneath each "Tub Girder". Since there are two "Tub Girder" in the project, there will be two insertion points located on each support line. |  |
| 4 | Enter Transverse Offset as -12 and +12 to relocate the insertion points on the support line | |
| 5 | Repeat the same to create other insertion points and set their transverse offset values | |
| 6 | Skew angle and transverse offset parameters for support lines that have skew > 0. User need to enter T value for skewed supports. 
Skew angle and longitudinal offset parameters for support lines that have skew > 0.
| |
Offset values use PGL as the reference point.  |
Follow the below steps to copy and paste all inputs from our data set.
| 1 | Navigate to Insertion Point under Bridge Geometry. |
| 2 | Copy Bridge Parameters from model inputs and paste into OpenBrIM. |
Insertion point layout is given below.
Copy the desired data with the automatic copy button in the upper left corner. Click on the first cell in and use the Ctrl+V shortcut to paste.  
If icon won’t appear, collapse page tree menu by clicking on arrow or using shortcut “[”.  While pasting large data, it would be handy to turn of Auto-refresh . 
|
Insertion Point |
|---|
Bridge Parameters |
IP1 Abut1 0 -12 IP2 Abut1 0 12 IP3 Pier2 0 -12 IP4 Pier2 0 12 IP5 Pier3 0 -12 IP6 Pier3 0 12 IP7 Abut4 0 -12 IP8 Abut4 0 12 |
Add Comment