Analysis Steps

Analysis Setting

Table 1: AEC|BOLT

1	Go to Analysis. Under the AEC\|BOLT tab, go to the Tributary section. Click on Run Tributary Analysis. Analysis was done.	Verifies Tributary Analysis
2	If you have a Live Load Reduction Load, "LLR" should appear in the 1st column.	Verifies Live Load Reduction load template imported
3	Set "Do not Consider cut out if area is bigger 100 (ft²) rule" to "80". And make sure the value in the cell	Verifies "Do not Consider cut out if area is bigger 100 (ft²) rule" can be changed
4	Click the "Tributary Correction Factors" button under Tributary Analysis Setting. Check see all the columns with live load reduction in this section.	Verifies "Tributary Correction Factors" operation.
5	In the C2 column in the 2nd row at spreadsheet, enter 1.10 to the "Tributary Area Factor" value. Check the color change of the cell whose value has changed	Verifies "Tributary Correction Factors" operation.
6	Changes occurred in the "Changes After Last Code Check" cell because we made a change in Analysis Setting. Click "View Changes" and check last change	Verifies that changes are saved
7	Click the "Run Tributary Analysis" button again. After the analysis is finished, check that the "Last Analysis Time" value has changed.	Verifies Last Analysis Time operation
8	Click the "Tributary Correction Factors" button again. And check that the changed value is present there. Click the show button as in the figure and check the drawing created in CAD view.	Verifies Tributary Correction Factors CAD view
9	CAD view
10	Go to Global FE Model. Change the "Run Mesh" button from False to True. Click the Generate Fem button. Check values in table and 3D view	Verifies Generate FEM operations
11	3D view
12	Click Run Analysis and perform Analysis. Set "Line Forces" to the bottom 1st cell. Set Fy (Shear) to 2nd cell and Self Weight.CASE to 3rd cell. Compare the image on the screen with the image in the figure.	Verifies Analysis and 3D views of Analysis Results
13
14
15
16
17
18
19
20
21