Analysis Steps

Analysis Setting

1	Go to Analysis. Under the AEC\|BOLT tab, go to the Tributary section. Click on Run Tributary Analysis. Analysis was done.	Verifies Tributary Analysis
2	If you have a Live Load Reduction load, "LLR" should appear in the 1st column.	Verifies Live Load Reduction load template imported
3	Set "Do not Consider cut out if area is bigger 100 (ft²) rule" to "80". And make sure the value in the cell	Verifies "Do not Consider cut out if area is bigger 100 (ft²) rule" can be changed
4	Click the "Tributary Correction Factors" button under Tributary Analysis Setting. In this section, can see all the columns with live load reduction or not .	Verifies "Tributary Correction Factors" operation.
5	In the C2 column in the 2nd row at spreadsheet, enter 1.10 to the "Tributary Area Factor" value. Check the color change of the cell whose value has changed	Verifies "Tributary Correction Factors" operation.
6	Changes occurred in the "Changes After Last Code Check" cell because we made a change in Analysis Setting. Click "View Changes" and check last change	Verifies that changes are saved
7
8
9
10
11
12
13
14
15
16
17
18
19