| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Follow the next steps to create a load rating template. |
...
Under Templates for Code Check and Load Rating/ Steel I Girder Load Rating, select Strength Combination Table and Service Combination Table columns as LoadRatingLCT in Analysis Results.
...
Similar to the Steel I Girder Code Check Template, enter the inputs for Appendix B6 columns.
| Tip |
|---|
Load rating template is completed. |
...
Go to Steel I Girder Load Rating under Templates for Code Check and Load Rating on the tree view.
...
Copy General and Appendix B6 from model inputs and paste into OpenBrIM.
...
Steel I Girder Load Rating
...
General
| Code Block |
|---|
SIGLRT1 LoadRatingLCT LoadRatingLCT 1.0000 YES Unshored Construction |
Appendix B6
...
| Info |
|---|
After clicking on ‘Templates for Code Check and Load Rating> Steel I Girder Load Rating' in the navigation treeview, follow the steps to define the Steel I Girder Load Rating Template. You can use the collapsed documentation page below for more information on the explanations of each parameter. |
| Expand | ||
|---|---|---|
| ||
| Steel I Girder Load Rating T [SIG] |
| 1 | 🖱️ Click the three-dots icon on the Strength (Load Rating Combination) cell, and then set LoadRatingLCT. |  | ||||||||||
| 2 | As a result of these operations, an issue will appear on the OpenBrIM screen. This does not necessarily mean that any operation was done incorrectly. The issue will be resolved when the load rating combination is define in the next step. |  | ||||||||||
| 3 |
| |||||||||||
| 4 | 🖱️ Click the three-dots icon on the Service (Load Rating Combination) cell, and then set LoadRatingLCT. |  | ||||||||||
| 5 | 🖱️ Keep the Condition Factor, Include Haunch for Section Properties? and Type of Construction as default. |  | ||||||||||
| 6 | 🖱️ Keep the Appendix B6 parameters as default. |  | ||||||||||
| 7 | Proceed to the next step to verify the model. | |||||||||||
| Anchor | ||||
|---|---|---|---|---|
|
| Tip |
|---|
The completed steel i girder load rating template is illustrated below. Please verify that you have the same model on your end by examining each view provided here. For more information on how to perform visual checks, refer to the quick tips. |
...
| Tip |
|---|
To view the entire procedure explained on this page, please watch the recorded Video below. |
...