Foundation walls are defined and drawn from this section.
...
Figure 1
→ Click Foundation Wall button as shown in the “Foundation Wall” button (Figure 1).
...
Figure 2
→ You will see the question in your AutoCAD command line (Figure 2). Enter the floor number at which the foundation wall will be drawn to AutoCAD command line as demonstrated in Figure 2to be generated.
...
Figure 3
→ Draw the foundation wall analytical line (center line as the centerline of the foundation wall ) as illustrated in (Figure 3).
...
Figure 4
→ Select the material of the foundation wall and enter the thickness of the foundation wall in the spreadsheet as shown in (Figure 4).
→ Click No the ”No Break Pts Pts” button to add break points breakpoints. Click to the point where break point the breakpoint(s) to be added.
Once the foundation wall is divided into parts by break points breakpoints, propeties the properties of each part such as thickness or offset values can be entered differently. To enter different thickness or offset value to foundation wall parts enter “,” between each value as illustrated in Figure 5.
...