...
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Follow the next steps to define deck cross-sections. |
...
You need to define at least 2 deck cross-sections along the deck.
...
Pick 1st and 2nd Support Lines with no longitudinal offsets.
...
...
Pick 1st and 2nd Support Lines with no longitudinal offsets.
...
Go to Deck Cross Section tab.
...
Pick the Girders for haunch locations.
...
Enter the deck dimensions.
...
...
Go to Cross-Section under Deck on the tree view.
...
Copy Location, Deck Cross Section from model inputs and paste into OpenBrIM.
| Tip |
|---|
Completed deck cross section is illustrated below. |
...
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Follow the next steps to define concrete deck. |
...
Go to Concrete Deck on tree view.
...
...
Pick Cross-sections graphically.
...
...
Import deck Material and assign it.
...
| Expand | ||
|---|---|---|
| ||
You can view the previously imported materials in Properties->Materials on the tree view |
...
Go to Concrete Deck under Deck on the tree view.
...
Copy General from model inputs and paste into OpenBrIM.
| Tip |
|---|
Completed deck cross section is illustrated below. |
...
Deck Cross-Section
...
Concrete Deck
...
Location
| Code Block |
|---|
DCS1 Abut1 0
DCS2 Abut4 0 |
Deck Cross Section
| Code Block |
|---|
DCS1 [G1,G2,G3,G4] 486 45 9 9 9
DCS2 [G1,G2,G3,G4] 486 45 9 9 9 |
General
...
The concrete deck element for the Steel I-Girder Training Example can be modeled using this section of the workflow. For further guidance, refer to the following pages in the documentation under this section.
...