Content Comparison

The Diaphragm object serves as a connection element between I-Girders . Both the FEM and 3D models are generated based on the parameter definitions listed below.

Diaphragm

Girders: Specify the girders for which the diaphragms will be generated.

Station on Girders (from Right End): Assume the right-hand side as the starting point for station definition when viewed up-station from the alignment.

Thickness: This parameter is used to specify the thickness of the diaphragm in the bridge’s transverse direction.

Material: Assign a material to the diaphragm. Materials can be selected from previously defined options or imported as needed.

Top Offset (from Bottom of Top Flange): For a visual representation, refer to the figure below.

Bottom Offset (from Top of Bottom Flange): For a visual representation, refer to the figure below.

Image Modified