...
Navigate to Bridge Geometry > Support Lines |
|
To create the support line at Station 23846.1221 ft for the Bridge, click Click on the three-dot icon located on the first cell of the Bridge and set it to "Bridge1". | |
Follow the same process to create the support lines for the remaining structures at their respective stations. Set the support line for Pier1 at Station 23897.3196 ft, Pier2 at Station 23982.2802 ft, and Abut2 at Station 24026.8438 24027 ft. |
|
Define the skew angle of the support line as in the figure |  |
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
...
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
...
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
| 1 | To access additional details on each parameter, please refer to the following page. |
| 2 | Navigate to Support Lines under Bridge Geometry. |
| 23 | Copy Bridge Parameters from model inputs and paste into OpenBrIM. |
...
| Tip |
|---|
Completed Support Lines are illustrated below. |
...
...
|
...
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
...
Support Lines | |||||
|---|---|---|---|---|---|
Bridge Parameters | |||||
|