...
Section: Assign a section for the diaphragm.
Offset from Edge Center of Web :The parameter represents the offset amount taken from the center of the girder web flange boundary for to the diaphragm object.
...
Offset from Top of WebGirder: The parameter represents the offset amount taken from the top flange boundary of the girder for the diaphragm object.
...
Type [Truss/Beam] : The finite element representation is in the form of a truss or beam. The finite element representation is in the form of a truss or beam. Trusses can be used in cases where axial forces (tension and compression) are needed for calculations, while beams can be chosen for cases where bending, shear, and axial forces must be taken into account.
Orientation Angle: This parameter can be used to specify the orientation angle of the diaphragm.
...
FEA
Axial Rigidity Coefficient: This parameter can be used to define the axial rigidity of the element, which is directly related to its stiffness. Thus, it plays a crucial role in the analysis and design of structural components.
...
Geometry
Chord-Vertical Distance of WP from the Top of the Girder: The location of the FE line in the vertical direction relative to the top of the girder can be adjusted using this parameter. The definitions for this tab will affect both the 3D and FE models.
Chord-Horizontal Distance of WP from the Center of the Web:The horizontal distance of the WP from the center of the web can be adjusted using this parameter. This definition will affect both the 3D and FE models.
...