| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Follow the next steps to create a load rating template. |
...
| Info |
|---|
After clicking on ‘Templates for Code Check and Load |
...
Rating> Steel I Girder Load Rating |
...
...
Select LL (Fatigue) case.
...
...
' in the navigation treeview, follow the steps to define the Steel I Girder |
...
| Tip |
|---|
Load rating template is completed. |
...
Go to Steel I Girder Load Rating under Templates for Code Check and Load Rating on the tree view.
...
Copy Analysis Results, Bridge Parameters, Fatigue Parameters, Other and Appendix B6 from model inputs and paste into OpenBrIM.
...
Load Rating Template. You can use the collapsed documentation page below for more information on the explanations of each parameter. |
| Expand | ||
|---|---|---|
| ||
| Steel I Girder Load Rating T [SIG] |
| 1 | 🖱️ Click the three-dots icon on the Strength (Load Rating Combination) cell, and then set LoadRatingLCT. |  | ||||
| 2 | As a result of these operations, an issue will appear on the OpenBrIM screen. This does not necessarily mean that any operation was done incorrectly. The issue will be resolved when the load rating combination is define in the next step. |  | ||||
| 3 |
| |||||
...
| |||||
...
| ||||
...
| |||||
...
Steel I Girder Load Rating
Analysis Results
| Code Block |
|---|
SIGLRT1 LoadRatingLCT LoadRatingLCT 1 LLFat |
Bridge Parameters
| Code Block |
|---|
SIGLRT1 1000 |
Fatigue Parameters
| Code Block |
|---|
SIGLRT1 200 200 50 0.1 2 2 MainArterialStateRoute |
Other
| Code Block |
|---|
SIGLRT1 YES 1 |
Appendix B6
| 4 | 🖱️ Click the three-dots icon on the Service (Load Rating Combination) cell, and then set LoadRatingLCT. |  | |
| 5 | 🖱️ Keep the Condition Factor, Include Haunch for Section Properties? and Type of Construction as default. |  | |
| 6 | 🖱️ Keep the Appendix B6 parameters as default. |  | |
| 7 | Proceed to the next step to verify the model. | ||
| Anchor | ||||
|---|---|---|---|---|
|
| Tip |
|---|
The completed steel i girder load rating template is illustrated below. Please verify that you have the same model on your end by examining each view provided here. For more information on how to perform visual checks, refer to the quick tips. |
...
| Tip |
|---|
To view the entire procedure explained on this page, please watch the recorded Video below. |
...