Content Comparison

Navigate to Bridge Geometry > Roadway Alignment

Enter Start Station as 0.

To define alignment properties, click on the three-dot icon located on the cell, and then select "Editor".

To add a circular segment, click on the + icon located next to "Horizontal" in the editor.

Enter a length of 520 feet, a radius of 700 feet, and select "Towards Right" as the direction.

To define the alignment cross-section at a specific station, click on the + icon located next to "Transverse".

Enter the cross-section Station as 0 ft.

Enter the Left Edge to PGL distance as 20 ft. This distance is the length from the left edge to the centerline of the alignment.

To add a section component, click on the + icon located next to "At Sta+0".

Enter the Station as “0” ft.

Enter the Width as 40 ft and Slope as %-5.

Click again + icon next to the Transverse to define the alignment cross-section at a new specific station.

Enter the Station as “520” ft and Left Edge to PGL as 20.

Enter the Width as 40 ft and Slope as %-5 under “At Sta 5+20” tab.

Click Accept.