| Excerpt | ||
|---|---|---|
| ||
Point loads on the pile’s top nodes can be applied to piles at the specified stage based on the definitions of the parameters listed below. InputsSingle Pile/Pile Layout [Single Pile / Pile Layout]: This parameter is required to specify whether the applied loads will be defined for a single pile or for a pile layout. Single Pile |
...
Individual Piles: (optional)
Stage: (optional)
Fx [kip]:
Fy [kip]:
Fz [kip]:
Mx [kip-ft]:
My [kip-ft]:
...
: If the parameter Single Pile/Pile Layout is defined with the option Single Pile, this parameter can be used to further specify the single pile to which the load will be applied. Pile Layout: If the parameter Single Pile/Pile Layout is defined with the option Pile Layout, this parameter can be used to specify the pile layout whose piles will have the load applied. Stage: Select a stage to apply the load. Fx: Force in the longitudinal direction along the PGL. Fy: Force in the direction perpendicular to the PGL. Fz (Gravity): Force in the vertical direction. A positive value indicates a load in the global -Z or gravity direction. Mx: Moment in the longitudinal direction along the PGL. My: Moment in the direction perpendicular to the PGL. Mz: Moment in the vertical direction.
|
