...
| 1 | 🖱️ Click three-dots icon on Insertion Point cell and click Select. |
| ||||||||||
| 2 | 🖱️ Select Insertion Point as a IP1 and Click OK. |   | ||||||||||
| 3 |
| |||||||||||
| 4 | 🖱️ Keep the Tx as default. |  | ||||||||||
| 5 | 🖱️ Click the three-dots icon on the Ty and Tz cell, and then set Fixed. |
| ||||||||||
| 6 | 🖱️ Keep the Rx, Ry, Rz, Bearing Rotation and Transfer Forces to Substructure as default. |
| ||||||||||
| 7 | 🖱️ Keep the bearing’s name as default. | |||||||||||
| 8 | When the steps are completed, the shared screenshot displayed in the adjacent cell should be visible in the 3D view of OpenBrIM. | 
| ||||||||||
| 9 | To model all of the bearings, copy the data below and paste the parameters into the first cell in the OpenBrIM spreadsheet. Refer to the quick tip for an easy guide on how to perform the copy operation. After completing the copy, proceed to the next step to verify the model. | |||||||||||
...
| Anchor | ||||
|---|---|---|---|---|
|
| Tip |
|---|
The completed bearing fixity definitions for bearings are illustrated below. Please verify that you have the same model on your end your model matches by examining each view provided here. For more information on how to perform performing visual checks, refer to the quick tips. |
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
...
| Tip |
|---|
To view the entire procedure explained on this page, please watch the recorded Video below. |
...