Content Comparison

Go to Roof under Slab Design from tree view.

Click “General” and go to Corner Zone tab.

Click “Generate Corner Zones”
Check drawing is created in CAD view and data is created in spreadsheet.

Click “Draw Corner Zone” from same spreadsheet.

Draw a corner zone as shown in the figure.

Make sure the drawing is created in Cad view, then delete it.

Go to “Stress Line” under Corner Zones from same spreadsheet.

Click “Run Stress Line Generation” and make sure stress line spreadsheet created

Set data in SL-C1-SW-CZ 3 row as in the figure.

Click on “Drawn Stress Line”. Draw a stress line between column C3 and SW-1 CZ 5. Check that stress line is drawn in CAD view and then delete it.

Click on “Click Strip Results” and select "Direction 1".

Check that Top Reinforcement drawing has been created in the CAD view.

Click “Refine Stress Line” and select Direction Both at same spreadsheet.

Delete suggested lines from BDS.

Go to Top Reinforcements under Roof from tree view.

Click Design Summary button and select “Column Strip Reinforcement”.

Click “Generate Reinforcements”