Content Comparison

Design of slab top reinforcement is made in this section.

...

Figure 1

Click “Generate Generate Reinf. Rectangles Reinforcements” Reinforcements button as shown in Figure 1 to generate rectangles where the reinforcement will be placed.

Stress line generation must be done before the generation of reinforcement rectangles.

...

Yellow rectangle is intensity rectangle, white rectangle is distribution rectangle and navy blue rectangle is reinforcement length rectangle.

...

Figure 2

Click “Draw Draw Slab Reinf. ” button as shown in Figure 1 to draw additional reinforcement manually. Then click “Draw Region” Draw Region button as shown in Figure 3 to draw region for reinforcement.

Image Modified

Figure 3

...

Figure 4

Rebar, spacing, #of rebar properties of strip areas can be edited as shown in Figure 4. Reinforcement data will be automatically written on reinforcement drawing as illustrated in Figure 4.Click “Show Region”

D/C ratio will be automatically calculated depending on SAFE results and rebar data entered.

Click Show Region button as shown in Figure 4 to see where reinforcement region is.

Click “Merge Reinforcement” Merge Reinforcement button as shown in Figure 1 to merge reinforcements where their regions are intersected as illustrated in Figures 5-6. Select the pivot reinforcement then select reinforcements to merge and press “Enter” Enter. Multiple reinforcements can be selected for merging after pivot reinforcement is selected.

...