| Info |
|---|
Please follow the instructions provided below to add the pier columns. |
| 1 | Navigate to Pier > Pier Column |  |
| 2 | Click three-dots icon on the tree view. | 2the Cap cell and set pier caps according to project. Then enter the name. |
| 3 | Click three-dots icon on the Section Data and click edit. Enter the section data as follows for Column1.
|  |
| 4 | Repeat the previous steps and enter the section data as follows for Column2 and Column3. Column2:
Column3:
|
|
| 5 | Enter Transverse Offset [ft] and Bottom Elevation [ft] data as in the figure. |  |
| 6 | You can make adjustments to the "FEM" tab if you wish. |  |
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
...
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
Navigate to Pier Columns under Pier on the |
tree view. |
Copy Column from model inputs and paste into OpenBrIM. |
Go to FEM under Pier on the tree view. |
Copy FEM data from model inputs and paste into OpenBrIM. |
| Tip |
|---|
The pier columns that have been created are illustrated below. |
...
...
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
Pier Column | |||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Column | Section Data | FEA | |||||||||||||||||||||||||||
Column1 | Column2 | Column3 | |||||||||||||||||||||||||||
|
|
|
|
| |||||||||||||||||||||||||