Versions Compared

Version Old Version 2 New Version Current
Changes made by

mert.goktas

mert.goktas

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

1

Navigate to Bridge Geometry > Insertion Point

2

To create the first insertion point, click on the three-dot icon located on the first cell of the Location and set its location to "Abut1".

3

For each support line, there should be one insertion point positioned beneath each "Tub Girder". Since there are two "Tub Girder" in the project, there will be two insertion points located on each support line.

4

Enter Transverse Offset as -12 and +12 to relocate the insertion points on the support line

5

Repeat the same to create other insertion points and set their transverse offset values

6
Expand
titleQuick Tip: Skew angle & Offset parameter calculation

Skew angle and transverse offset parameters for support lines that have skew > 0. User need to enter T value for skewed supports.

Image RemovedImage Added

Skew angle and longitudinal offset parameters for support lines that have skew > 0.

Image RemovedImage Added

Insert excerpt
_ConfluenceInclusions
_ConfluenceInclusions
nameTubGirderPGL
nopaneltrue

...

Insert excerpt
_ConfluenceInclusions
_ConfluenceInclusions
nameCopyPaste
nopaneltrue

1

Navigate to Insertion Point under Bridge Geometry.

2

Copy Bridge Parameters from model inputs and paste into OpenBrIM.

...

Tip

Insertion point layout is given below.

...

Insert excerpt
_ConfluenceInclusions
_ConfluenceInclusions
namePasteTip
nopaneltrue

Insertion Point

Bridge Parameters

Code Block
languagexml
IP1	Abut1	0	-12
IP2	Abut1	0	12
IP3	Pier2	0	-12
IP4	Pier2	0	12
IP5	Pier3	0	-12
IP6	Pier3	0	12
IP7	Abut4	0	-12
IP8	Abut4	0	12