Content Comparison

If the user wishes to apply static wind on live load, they can utilize this option.

The line load shall be applied onto the central line of the lane position designated by the user.

In the "Wind on Live Load AASHTO" section, users can choose defined lane positions. The line load will then be applied to these positions separately. For each designated lane location, a unique result scenario will be generated. The critical envelopes of these result scenarios will be used in subsequent design proceduresTo define wind loads for live loads, several parameters must be established, including lane positions. These lane positions will be utilized in the sections for WL AASHTO and WL Custom. This section allows users to specify the relevant lane positions.

Geometry

Here, the user can specify the center line of the lane, which can then be utilized in the Wind on Live Load AASHTO or Wind on Live Load Custom sections.

Bridge: Select the bridge

Start Station: Specify the start station along the PGL.

End Station: Specify the end station along the PGL.

Transverse Offset: Use this parameter define the centerline of the lane, consider 0 as the PGL location.