Content Comparison

In OpenBrIM, "support linesSupport Lines" is the term used to describe the locations of abutments and piers in plan view. These lines are typically placed at the centerline of piers and the front face of backwalls for abutments, and are also used to determine the extents of the deck and beams.

Bridge Parameters

It is necessary to create a single support line for each abutment and pier location.

Bridge: Since OpenBrIM allows for the modeling of multiple bridges, you should specify the bridge on which the support line will be placed using this parameter.

Station: The station of the support line can be defined using this parameter. The generation of the support line with respect to the station is based on PGL (Proposed Grade Line).

Skew Angle: Define the skew angle of the support line. See below screenshot for positive and negative skew angles description.

Transverse Offset: Specify the transverse offset to move the support line center from PGL (Proposed Grade Line).

3D Visual

Support Line Width: It is used to determine the width of the support line.

Show/Hide [Show/Hide]: This parameter is used to toggle the object in 3D view.

Label: This parameter can be used to change the name of the object in 3D view.