All parameters and definition logic for this object are the same as those for the pier cap, so please refer to the pier cap's documentation. The only difference between this object and the pier cap is that this object can be used to define piles below, whereas the pier cap object requires a pier column below.
| Excerpt | ||
|---|---|---|
|
General
Location:
Straight-Tapered Section / Length:
Slope Option:
Slope:
Top Elevation Offset from Alignment [ft]:
Transverse Offset [ft]:
Longitudinal Offset [ft]:
Section Type:
Circular-Parabolic Variation
Circular-Parabolic Section:
Cap Length [ft]:
FEM
Generate FEM?:
Rigid Section:
Additional Break Points [ft]:
...
|