| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Follow the next steps to create pile capacity check. |
...
Go to Substructure Code Checks/Pile Capacity Check.
...
...
Set PileCapacityCCT to Template.
...
Select Pile Cap and set Footing1.
...
...
| Info |
|---|
After clicking on ‘Substructure Code Checks> Pile Capacity Check' in the navigation treeview, follow the steps to define the Pile Capacity Check. You can use the collapsed documentation page below for more information on the explanations of each parameter. |
| Expand | ||
|---|---|---|
| ||
| Pile Capacity Check [SIG] |
| 1 |
|    | ||||
| 2 | As a result of these operations, an issue will appear on the OpenBrIM screen. This does not necessarily mean that any operation was done incorrectly. The issue will be resolved when the template is defined in the next step. |  | ||||
| 3 |
| |||||
...
| |||||
...
| ||||
...
| |||||
Go to Pile Capacity Check under Superstructure Code Checks on the tree view.
Copy General from model inputs and paste into OpenBrIM.
...
Pile Capacity Check
General
| 4 |
|  |
| 5 |
|  |
| 6 | Proceed to the next step to verify the model. | |
| Anchor | ||||
|---|---|---|---|---|
|
| Tip |
|---|
The completed pile capacity check is illustrated below. Please verify that you have the same model on your end by examining each view provided here. For more information on how to perform visual checks, refer to the quick tips. |
...
| Tip |
|---|
To view the entire procedure explained on this page, please watch the recorded Video below. |
...