...
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Follow the next steps to define concrete deck. |
...
Go to Concrete Deck on tree view.
...
| Info |
|---|
After clicking on 'Superstructure> Deck> Concrete Deck' in the navigation treeview, follow the steps to define the Concrete Deck. You can use the collapsed documentation page below for more information on the explanations of each parameter. |
| Expand | ||
|---|---|---|
| ||
| Concrete Deck [SIG] |
| 1 |
|
...
 |
...
| 2 |
...
Select the Cross Section and enter values for the Offset from Support Line, Skew Angle, and Variation with Next Segment.
...
|
...
Select the Girders.
...
Click three-dots icon on Deck Reinforcement Data cell and Edit.
...
Select the Deck Rebar Material, Long. Deck Rebar (Top) and Long. Deck Rebar (Bottom) and enter values for the Start Station, End Station, Rebar Spacing, Clear Cover and Concrete creep adjustment factor.
...
Enter the Taper, Continuous at Start, Continuous at End and Material.
...
| Expand | ||
|---|---|---|
| ||
Do not forget to assign the related material for each case. |
...
Go to 3D Settings tab to edit the Curve Refinement inputs.
...
the Cross Section Location cell, and then set Abut1. |   | |||||
| 3 | As a result of these operations, an issue will appear on the OpenBrIM screen. This does not necessarily mean that any operation was done incorrectly. The issue will be resolved when the bolt property is set in the next step. | |||||
| 4 |
| |||||
...
| |||||
...
| ||||
...
| |||||
...
Go to Concrete Deck under Deck on the tree view.
...
Copy General and 3D Settings from model inputs and paste into OpenBrIM.
| Tip |
|---|
Completed deck cross section is illustrated below. |
...
Concrete Deck
General
| Code Block |
|---|
Deck1 [[Abut1, 0, DCS1, 0, 2],[Abut4, 0, DCS1, 0, 2]] [G1,G2,G3,G4] YES NO NO Fc_4ksi [[0, 6360, A615_60, 5, 5, ASTMA615No8, ASTMA615No6, 2, 3, 1]] |
3D Settings
| Code Block |
|---|
Deck1 4.0000 |
...
Cross Sections
| Code Block |
|---|
Abut1 0.0000 DCS1 0.0000 Linear
Abut4 0.0000 DCS1 0.0000 Linear |
...
Girders
| Code Block |
|---|
G1
G2
G3
G4 |
...
Deck Reinforcement Data
...
| 5 |
|