Content Comparison

...

First, it should be specified where the user needs to navigate in the data spreadsheet within OpenBrIM. This instructional text should be added using the Info Panel command, as shown below. The text in the panel on every page should be the same, except for the navigation location in the treeview.

...

After clicking on '...> ... > ...' in the navigation treeview, follow the steps to define the ..... You can use the collapsed documentation page below for more information on the explanations of each parameter.

Section 2: Link to Parameter Descriptions

...

After the instruction numbered table, the user should be directed to the section where they will copy the input parameters. Additionally, guidance should be provided as seen below for the step that follows the copying process. This instructional text should be added using the Note Panel command as seen below.

...

To model all the .... , copy the data below and paste the parameters into the first cell in OpenBrIM spreadsheet. Refer to the quick tip for an easy guide on how to perform the copy operation. After completing the copy, proceed to the next step to verify the model.

Section 6: Copy Data

In the section where the parameters to be copied are located, there should be all the input parameters that can be used for copy operation as seen below

...

Quick Tip page explaining how to transfer input parameters to OpenBrIM should be added to the document as seen below.

...

Section 7

...

After completing the copy operation, the document should display the following message, indicating to the user the need to verify the correctness of their work in OpenBrIM 3D View/FEA View and Spreadsheet. This instructional text should be added using the Success Panel command.

...

Section 7
Code Block The completed .... are illustrated below. Please verify that you have the same model on your end by examining each view provided here. For more information on how to perform visual checks, refer to the quick tips.

Section 8

This section should contain screenshots of the completed model and instructions for verifying its completion.
The Model Quick Tip should be added to the document.

...

The message 'To view the entire procedure explained on this page, please watch the recorded Video below.' should be added to the document. This instructional text should be added using the Success Panel command. Finally, a video demonstrating the implementation of all the information explained in the document should be recorded and added to the document.

...

To view the entire procedure explained on this page, please watch the recorded Video below.

...

• For an example, you can visit the following link.