Versions Compared

Version Old Version 54 New Version 55
Changes made by

Umut Nuhat Sevinc

Umut Nuhat Sevinc

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel
panelIconIdatlassian-info
panelIcon:info:
bgColor#DEEBFF

Follow the next steps to add the pier cap.

1

Go to Pier Cap under Pier on the tree view.

2

Click three-dots icon on the Location cell and select a support line.

3

Click three-dots icon on the Straight-Tapered Section / Length cell and click Edit.

4

Enter Section Length along Y-Y starting from right.

5

Select Start Section and End Section.

6

Go back to pier cap, select Slope Option as alignment.

Image RemovedImage Added
7

Edit Top Elevation Offset from Alignment, Transverse Offset, Longitudinal Offset and Section Type value.

8

Go to FEM tab and select a section for Rigid Section.

Image Added
9

Go to Longitudinal Reinforcement tab and edit Reinforcement Data.

Image RemovedImage Added

Insert excerpt
_ConfluenceInclusions
_ConfluenceInclusions
nameOffset
nopaneltrue

Insert excerpt
_ConfluenceInclusions
_ConfluenceInclusions
nameCopyPaste
nopaneltrue

1

Go to Pier Cap under Pier on the tree view.

2

Copy End Bent from model inputs and paste into OpenBrIM.

3

Go to FEM under Pier on the tree view.

4

Copy FEM data from model inputsand paste into OpenBrIM.

Tip

     Completed pier cap is illustrated below.

Anchor
ModelInputs
ModelInputs

Insert excerpt
_ConfluenceInclusions
_ConfluenceInclusions
namePasteTip
nopaneltrue

Pier Cap

Section Data

Pier Cap

Code Block
PierCap1	Pier2	Prismatic	[[72, PierCapRec_Taper, PierCapRec_Mid],[438, PierCapRec_Mid, PierCapRec_Mid],[72, PierCapRec_Mid, PierCapRec_Taper]]	PierCapRec_Mid	40	Alignment	0.2	-10	0
PierCap2	Pier3	Prismatic	[[72, PierCapRec_Taper, PierCapRec_Mid],[438, PierCapRec_Mid, PierCapRec_Mid],[72, PierCapRec_Mid, PierCapRec_Taper]]	PierCapRec_Mid	40	Alignment	0.2	-10	0

FEM

Code Block
PierCap1	Yes	RigidSection	[0]
PierCap2	Yes	RigidSection	[0]

Section Data

Code Block
6	PierCapRec_Taper	PierCapRec_Mid
36.5	PierCapRec_Mid	PierCapRec_Mid
6	PierCapRec_Mid	PierCapRec_Taper