Content Comparison

Navigate to Deck > Concrete Deck.

Click on the "Girders" column. Click “pick” from the combobox.

Select the girders graphically you want to create a deck.

Click on the three-dot icon located on the first cell of the Cross-Section and click “Edit”

Click on the three-dot icon located on the first cell of the “Cross Section Location”

Then designate the locations for the “Cross-Sections” data.

Associate a "Cross Section" with each "support line." This assignment will result in a specific deck cross-section being established between the two selected support lines.

In cases where the "Cross Section" changes between two support lines, the "Variation w/Next Segment" parameter is employed to define the attributes of the transitions between the sections.

Navigate back to General spreadsheet.

Set Material type as Fc_5ksi.

Click on the three-dot icon located on the first cell of the Deck Reinforcement Data and click “Edit”

Enter the Deck Reinforcement Data as in the figure.

After completing this step, the reinforcement process for the "Deck1" deck will be finished.

Navigate to Concrete Deck under Deck on the tree view.

Copy General and 3D Settings from model inputs and paste into OpenBrIM.

General

3D Settings

Cross-Sections

Girders

Deck Reinforcement Data