...
| Info |
|---|
For this concept to work correctly within the project's spreadsheet, document, CADD, and criteria check units, the following considerations should be taken into account: |
Description | Incorrect Example | Correct Example | |
|---|---|---|---|
| 1 | The missing UT and UC of parameters related to the units of area and section modulus. |  |  |
| 2 | If you are using the parameters within a document and the unit is missing, in the 'where' section, it will display the values without showing the unit and will display the result in the default value. |   |   |
| 3 | The assigned Unit Category to parameters must be defined within the project. Therefore, ensure that the given UC value is within 'Base_DesignSubUnits' to make sure it is valid. |  |  |
| 4 | The Internal Unit Category should not be defined at the parameter. Instead, Property should be used. Because in the US unit system, Internal and Property are completely equivalent. However, in the SI unit system, Internal behaves according to the US unit system. For this reason, a different category should be used instead of Internal. |  |  |
| 5 | |||
| 6 | |||
| 7 |