| Info |
|---|
Please follow the instructions provided below to create the alignment where the bridge will be located. |
Navigate to Bridge Geometry > Roadway Alignment |   | |||||
Enter Start Station as 0. 23820 | ||||||
To define alignment properties, click on the three-dot icon located on the cell and then select "Editor". |   | |||||
To add a circular segment, click on the + icon located next to "Horizontal" in the editor. |  | |||||
Enter a length of 125.502 126 feet, a radius of 5741.4698 5742 feet, and select "Towards Left" as the direction. To add 2nd circular segments, please follow the previous step and enter the following values accordingly: Length: 477.0505 478 feet Radius: 623.3596 624 feet Direction: “Towards Left” |   | |||||
| ||||||
Click the + icon next to Vertical to define the vertical section at a specific station. Please enter the values for the 1st Vertical section as follows:
|   | |||||
2nd Vertical section
3rd Vertical section
4th Vertical section
|   | |||||
To define the alignment cross-section at a specific station, click on the + icon located next to "Transverse". |  | |||||
Enter the cross-section Station as 23786.0892 ft. |  | |||||
Enter the Left Edge to PGL distance as 28 ft. This distance is the length from the left edge to the centerline of the alignment. | ||||||
To add a section component, click on the + icon located next to "At Sta 237+086". Enter the Width as 55 ft and Slope as %2. |   | |||||
Click again + icon next to the Transverse to define the alignment cross-section at new specific stations. Enter 2nd Station as “23982.9396” “23983” ft and Left Edge to PGL as 28. Enter 2nd 3rd Station as “24081.3648” “24082” ft and Left Edge to PGL as 28.  |  | |||||
Enter the Width as 55 ft and Slope as %8.34 under “At Sta 239+82.94” 83” and “At Sta 240+81.36”82” tab. | ||||||
And Click “Accept” | ||||||
| ||||||
...