Content Comparison

In this section, you can specify the precast I girders you wish to analyze, along with their strength losses and the relevant code requirements you want to consider for this analysis.

This information is essential for conducting code checks.

Navigate Superstructure Code Checks > Prestressed I Girder Code Check

Click three-dots icon on Girder and click select

Set as G2 and G12 girders

2 Girders were selected from 2 different spans.
Code control will be made when one of the girder is in the middle of the distance and the other girder is close distance to the support.

Click three-dots iconon Code Check Template and assing PIGTemp both of them

Click three-dots icon on Detailed Calculation Position and click select.

Assign data as follows

• for PIG2 : 0.5L

• for PIG12 : 0.9L

Keep "Number of Code Check Location" parameter constant as defult value.

Navigate Loss Calculation Tab

Enter parameter values as in the figure

Navigate Shear Reinforcement tab.

Image Added

Image Added

Click three-dots icon on Shear Reinforcement data for PIGCC1 (PIG2)and click select.

In this section, we will establish the calculation for shear reinforcement compaction in a manner that is specific to each station. This will be done within the spreadsheet.