...
1 | Navigate to Loads > Influence Surface Based LL/BR/CE > Live Load Case | |
2 | In this step, we define the "Live Load Cases" for which limit states will be used. | |
3 | Select the (Influence Surface) loads that were defined in the previous step for the live load cases you wish to define. Next enter the names of the defined live load cases. | |
4 | Set the "Max for Stress Range (Fatigue)" parameter to "Yes" for the "LLFatCase" live load case. | |
5 | Navigate Design Lanes tab. | |
6 | To perform the design calculation, vehicle scenarios must be created on the roadway. To perform this, vehicle scenarios need to be applied to the 'Live Load Cases' that were defined previous step.
Click three-dots icon on Design Line Option cell and click Select.
Assign the design lanes to the 'Design Lane Options' as in the figure. |
...
Insert excerpt | ||||||||
---|---|---|---|---|---|---|---|---|
|
1 | Navigate to Live Load Case under Live Load on the tree view. | |
2 | Copy General and Design Lanes from model inputs and paste into OpenBrIM. |
...
Anchor | ||||
---|---|---|---|---|
|
Insert excerpt | ||||||||
---|---|---|---|---|---|---|---|---|
|
Vehicle | |||||
---|---|---|---|---|---|
Data | |||||
|
...
Design Lane | |||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Properties | Vehicles | Lane Load | Vehicle Placement Settings | Lane Placement Settings | |||||||||||||||||||||||||
|
|
|
|
|
...
Influence Surface | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
General | Centrifugal | ||||||||||
|
|