...
From any cell of the AASHTO_TYPE_III_BEAM row, click on three-dots icon to open Section Editor panel. |  |
Click + icon at the left top side of the screen. And Select Rebar | |
Enter:
Click Add. |  |
Enter:
Click Add. |  |
Click + icon at the left top side of the screen. And Select Tendon |  |
Enter:
Click Add. | 
|
Enter:
Click Add. | |
Enter:
Click Add. |
...
| Info |
|---|
Please follow the instructions provided below to set rebar detailing for Circle_prop_column |
From any cell of the Circle_prop_column row, click on three-dots icon to open Section Editor panel. |  |
Click + icon at the left top side of the screen. And Select Rebar | |
Navigate to the "Circular Layout" tab Enter:
Click Add. |  |
 |
...
| Info |
|---|
Please follow the instructions provided below to set rebar detailing for Rectangle_prop_EB1cap |
From any cell of the Rectangle_prop_EB1cap row, click on three-dots icon to open Section Editor panel. |  | |||||
Click + icon at the left top side of the screen. And Select Rebar | ||||||
Navigate to the "Draw Rebar Points" tab Enter:
Click Add. Manually position the rebar line within the section. And set data as follows:
Click Apply. | 
| |||||
Click … icon shown on created rebar. Click Points Spreadsheet. Copy the data below.
|  | |||||
Repeat the previous steps to define the Rebar into the Section |
| |||||
Select Rebar
Click Add.
Click Apply. | ||||||
Click … icon shown on created rebar. Click Points Spreadsheet. Copy the data below.
|  | |||||
Select Rebar Enter:
Click Add. Manually position the rebar line within the section. And set data as follows:
Click Apply. |
| |||||
Click … icon shown on created rebar. Click Points Spreadsheet. Copy the data below.
|  |
...