| Excerpt | ||
|---|---|---|
| ||
Typically, insertion points are used to model bearing locations, therefore, it is recommended to have one insertion point for each bearing. Location: Select the support lines Longitudinal Offset [ft]: Longitudinal offset along the PGL (Projected Grade Line) from the support line. Transverse Offset [ft]: Transverse Offset from the PGL  When working with a support line that has a skew angle greater than 0 in OpenBrIM, it is important for users to specify the transverse offset(T) along the support line, not along the PGL(Y). This is demonstrated in the figure below.  If a support line has a skew angle greater than 0 and longitudinal offsets greater than 0 are being used, then the longitudinal offset parameter is applied perpendicular to the support line.
|
Content Comparison
General
Content
Integrations