...
1 | Navigate to Loads > Live Load > Live Load Case | |
2 | In this step, we define the "Live Load Cases" for which limit states will be used. | |
3 | Select the (Influence Surface) loads that were defined in the previous step. Then enter the name. | |
4 | Assign Fatigue parameter of defined "Live Load Case" as in the figure. | |
5 | Navigate Design Lanes tab. | |
6 | To perform the design calculation, vehicle scenarios must be created on the roadway. To perform this, vehicle scenarios need to be applied to the 'Live Load Cases' that were defined previous step. Click three-dots icon on Design Line Option cell and click Select. Assign the design lanes to the 'Design Lane Options' as in the figure. |
...
Insert excerpt | ||||||||
---|---|---|---|---|---|---|---|---|
|
1 | Navigate to Live Load Case under Live Load on the tree view. | |
2 | Copy General, and Design Lanes from model inputs and paste into OpenBrIM. |
...
Insert excerpt | ||||||||
---|---|---|---|---|---|---|---|---|
|
Vehicle | |||||
---|---|---|---|---|---|
Data | |||||
|
...
Design Lane | |||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Properties | Vehicles | Lane Load | Vehicle Placement Settings | Lane Placement Settings | |||||||||||||||||||||||||
|
|
|
|
|
...
Influence Surface | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
General | Centrifugal | ||||||||||
|
|
...
Live Load Case | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
General | Design Lanes | ||||||||||
|
|