| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Follow the below steps to create the alignment where the bridge will be located. |
| 1 | Go to Bridge Geometry > Roadway Alignment. |  | |||||
| 2 | Enter Start Station as 0. | ||||||
| 3 | Click the three-dots icon on the cell and Click Editor to define alignment properties. |  | |||||
| 4 | Click + icon next to the Horizontal and add a circular segment. |  | |||||
| 5 | Enter Length as 530 ft, Radius as 700 ft, and Direction as Towards Right. |  | |||||
| 6 |
| ||||||
| 7 | Click + icon next to the Transverse to define the alignment cross-section at a specific station. |  | |||||
| 8 | Enter the cross-section Station as 0 ft. |  | |||||
| 9 | Enter the Left Edge to PGL distance as 20 ft. This distance is the length from the left edge to the centerline of the alignment. | ||||||
| 10 | Click + icon next to the At Sta+0 and add a section component. |  | |||||
| 11 | Enter the Width as 50 ft and Slope as %-5. |  | |||||
| 12 | Click Accept |  | |||||
| 13 |
| ||||||
...