Versions Compared

Version Old Version 24 New Version 25
Changes made by

mert.goktas

mert.goktas

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Tip

The Column Design Lines part is completed in this step.

Contents from above have been entered. Design Column, Verifies All, Verifies Selected, Rebar Templates, Showing w/o, Names

...

1

Go to Roof under Slab Design from tree view.

Click “General” and go to Corner Zone tab.

Click “Generate Corner Zones”
Check drawing is created in CAD view and data is created in spreadsheet.

Image Added

Tip

Verifies Generate Corner Zones

2
Expand
titleCAD view
Image Added

3

Click “Draw Corner Zone” from same spreadsheet.

Draw a corner zone as shown in the figure.

Make sure the drawing is created in Cad view, then delete it.

Image Added

Tip

Verifies Draw Corner Zone

4
Expand
titleCAD view
Image Added

5

Go to “Stress Line” under Corner Zones from same spreadsheet.

Click “Run Stress Line Generation” and make sure stress line spreadsheet created

Image Added

Tip

Verifies Run Stress Line Generation

6
Expand
titleCAD view
Image Added

7

Tip

8

Tip

9

Tip

10

Tip

11

Tip

12

Tip

13

Tip

14

Tip

15

Tip

16

Tip

17

Tip

18

Tip

19

Tip

20

Tip

21

Tip

22

Tip