...
| Tip |
|---|
The Column Design Lines part is completed in this step. Contents from above have been entered. Design Column, Verifies All, Verifies Selected, Rebar Templates, Showing w/o, Names |
...
Table 3: Slab Design
| 1 | Go to Roof under Slab Design from tree view. Click “General” and go to Corner Zone tab. Click “Generate Corner Zones” |  |
| ||||||
| 2 |
| ||||||||
| 3 | Click “Draw Corner Zone” from same spreadsheet. Draw a corner zone as shown in the figure. Make sure the drawing is created in Cad view, then delete it. |  |
| ||||||
| 4 |
| ||||||||
| 5 | Go to “Stress Line” under Corner Zones from same spreadsheet. Click “Run Stress Line Generation” and make sure stress line spreadsheet created |  |
| ||||||
| 6 |
| ||||||||
| 7 | Set data in SL-C1-SW-CZ 3 row as in the figure. |  |
| ||||||
| 8 | Click on “Drawn Stress Line”. Draw a stress line between column C3 and SW-1 CZ 5. Check that stress line is drawn in CAD view and then delete it. |  |
| ||||||
| 9 | tip
| ||||||||
| 10 |
| ||||||||
| 11 |
| ||||||||
| 12 |
| ||||||||
| 13 |
| ||||||||
| 14 |
| ||||||||
| 15 |
| ||||||||
| 16 |
| ||||||||
| 17 |
| ||||||||
| 18 |
| ||||||||
| 19 |
| ||||||||
| 20 |
| ||||||||
| 21 |
| ||||||||
| 22 |
| ||||||||
...