Content Comparison

Go to Column Design Lines from tree view.

Check that "Column Schedule" has been created in the CAD view.

Click Verify Selected and select columns in the figure.

Click run code check button and make sure selected column “C4” verified.

Click Verify All.

Make sure all column verified.

(Do not define vertical strips for arbitrary columns, cannot see analysis result in CAD view in C1 and C2 column)

Click Design Columns from Column Design Lines Spreadsheet.

Names

Go to C1 under Column Design Lines from tree view.

Click Column Design Line Data button and select Rebar Templates.

Click Draw Rebars and enter “2”.

Create rebar on each floor for column C1.

Click “Show Rebars” cell in Longitudinal Rebar for the 1st floor.

Make sure a coordinate table is created. Also set rebar class “#8”

Make same steps for other floors.

Click “Show Stirrups” cell in Strrup for 1st floor.

Click Draw Stirrup button and draw stirrups as in the figure

Click “Closed Torsional” cell in Strrup for 1st floor.

Select marked points with red arrow.

Check torsional rebar has occurred in CAD view.

Click “X Group Rebars” and select marked points with red arrow.

Click “Y Group Rebars” and select marked points with blue arrow.

Click “Clear Groupped Rebar List” for 1st Floor.

Make sure clear X and Y rebars group list