...
| 1 | Go to Foundation in the tree view. Enter Elevation feet -5 feet. |  |
| |||||||||||||||
| 2 | Go to the Mat below Foundation and click the Mat. Draw the Mat Edge between columns on Cad view. Enter values in the figure for blank cell |  |
| |||||||||||||||
| 3 |
| |||||||||||||||||
| 4 | Draw the Mat Piece for the Shear-Wall on Cad view. Enter values in the figure for blank cell |  |
| |||||||||||||||
| 5 |
| |||||||||||||||||
| 6 | Go to the Pile caps below Foundation and click the Template. |  |
| 7 |
| 8 | ||||||||||||
| Tip | 9 | |||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Tip | 10 | |||||||||||||||||
| Tip | 11 | |||||||||||||||||
| Tip | 12 | |||||||||||||||||
| Tip | ||||||||||||||||||
25. Go to the Pile caps spreadsheet and click the Template button. Click the Import pile caps button. Check the boxes in the screenshot. (40 Tonne P8-P9-P10-P11-P12) and click import.
...
| Info |
|---|
It gives the properties of the selected templates on the right side of Database. |
...
| ||||||||
| 7 | Enter the values in the table for the material and rebar values. |  |
| |||||
| 8 | Go to Pile Caps below Foundation, click Assign Pile Cap Template. Select the Circular column as the object, click enter. Set to Pile Template to P8 [40] and Pile Embedment Soil value 60 inch |  |
| |||||
| 9 |
| |||||||
| 10 |
| |||||||
| 11 |
| |||||||
| 12 |
| |||||||
| 13 |
| |||||||
...
...
| Info |
|---|
Enter the values in the table for the material and rebar values. |
Go to Pile Caps spreadsheet, click Assign pile cap template. Select the Circular column as the object, click enter. Choose one of the templates you imported (P8 [40] )
...