This section starts with a load geometry definition (surface) and proceeds with the corresponding load (surface load).
...
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Follow the next steps to add surface and the corresponding load definitions. |
| 1 | Go to Load Geometry Definitions/Surface/Quadrilateral in tree view. | -20221008-140841.png?version=1&modificationDate=1665238128402&cacheVersion=1&api=v2) |
| 2 | Select Bridge. | |
| 3 | Specify Start Station, End Station and Surface Width. |  |
| 4 | Go to Loads/Surface Load. | -20221008-141224.png?version=1&modificationDate=1665238352654&cacheVersion=1&api=v2) |
| 5 | Name surface load and select Surface. | |
| 6 | Enter Magnitude (Gravity) of the surface load. | -20221008-141532.png?version=1&modificationDate=1665238539072&cacheVersion=1&api=v2) |
| 7 | Specify Stage and Element (of which surface load to be applied). |
...
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
| 1 | Go to Quadrilateral under Load Geometry Definitions on the tree view. |
| 2 | Copy Surface, and Graphics from model inputs and paste into OpenBrIM. |
| 3 | Go to Surface Load under Loads on the tree view. |
| 4 | Copy General from model inputs and paste into OpenBrIM. |
...
| Anchor | ||||
|---|---|---|---|---|
|
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
Quadrilateral | |||||||||
|---|---|---|---|---|---|---|---|---|---|
Surface
| Graphics
| ||||||||
Surface Load | ||
|---|---|---|
General
|