Versions Compared

Version Old Version 36 New Version 37
Changes made by

Orkun Gülel (Unlicensed)

Murat Bedel (Unlicensed)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel
panelIconIdatlassian-info
panelIcon:info:
bgColor#DEEBFF

Follow the next steps to add the pier cap.

1

Go to Pier Cap under Pier on the tree view

2

Click three-dots icon on the Location cell and select a support line

3

Click three-dots icon on the Section Data cell and click Edit

4

Enter Section Length along Y-Y starting from right

5

Select Start Section and End Section

6

Go back to pier cap, select Slope Option as alignment

7

Edit Top Elevation Offset from Alignment value

8

Go to FEM tab and select a section for Rigid Section

9

Follow the next steps

below to match the same inputs as illustrated model.10

to make sure that inputs are matching with model

1

Go to Pier Cap under Pier on the tree view.

11
2

Copy End Bent from model inputs and paste into OpenBrIM.

12
3

Go to FEM under Pier on the tree view.

13
4

Copy FEM data from model inputsand paste into OpenBrIM.

Tip

     Completed pier cap is illustrated below.

Anchor
ModelInputs
ModelInputs

Expand
titleQuick Tip

Copy the desired data with the automatic copy button in the upper left corner.

Click on the first cell in and use the Ctrl+V shortcut to paste.

Pier Cap

Section Data

Pier Cap

Code Block
PierCap1	Pier2	[[72, PierCapRec_Taper, PierCapRec_Mid],[438, PierCapRec_Mid, PierCapRec_Mid],[72, PierCapRec_Mid, PierCapRec_Taper]]	Alignment	N/A	-10	0
PierCap2	Pier3	[[72, PierCapRec_Taper, PierCapRec_Mid],[438, PierCapRec_Mid, PierCapRec_Mid],[72, PierCapRec_Mid, PierCapRec_Taper]]	Alignment	N/A	-10	0

FEM

Code Block
PierCap1	Yes	RigidSection	[0]
PierCap2	Yes	RigidSection	[0]

Section Data

Code Block
6	PierCapRec_Taper	PierCapRec_Mid
36.5	PierCapRec_Mid	PierCapRec_Mid
6	PierCapRec_Mid	PierCapRec_Taper