End Bent
| Code Block |
|---|
PierCap1 Pier2 [[72, PierCapRec_Taper, PierCapRec_Mid],[438, PierCapRec_Mid, PierCapRec_Mid],[72, PierCapRec_Mid, PierCapRec_Taper]] Alignment N/A -10 0
PierCap2 Pier3 [[72, PierCapRec_Taper, PierCapRec_Mid],[438, PierCapRec_Mid, PierCapRec_Mid],[72, PierCapRec_Mid, PierCapRec_Taper]] Alignment N/A -10 0 |
Section Data
| Code Block |
|---|
6 PierCapRec_Taper PierCapRec_Mid
36.5 PierCapRec_Mid PierCapRec_Mid
6 PierCapRec_Mid PierCapRec_Taper |
PierCap1 Yes RigidSection [0]
PierCap2 Yes RigidSection [0]| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Follow the next steps to add the pier cap. |
| 1 | Go to Pier Cap under Pier on the tree view |  | |||||
| 2 | Click three-dots icon on the Location cell and select a support line | ||||||
| 3 | Click three-dots icon on the Section Data cell and click Edit |  | |||||
| 4 | Enter Section Length along Y-Y starting from right |  | |||||
| 5 | Select Start Section and End Section | ||||||
| 6 | Go back to pier cap, select Slope Option as alignment |  | |||||
| 7 | Edit Top Elevation Offset from Alignment value | ||||||
| 8 | Go to FEM tab and select a section for Rigid Section |  | |||||
| 9 | Follow the steps below to match the same inputs as illustrated model. | ||||||
| 10 | Go to Pier Cap under Pier on the tree view | ||||||
| 11 | Copy-paste related data from model inputs. | ||||||
| 12 |
| ||||||
| 13 | |||||||
| 14 | |||||||
| 15 | |||||||
| Tip |
|---|
Completed pier cap is illustrated below |
| title | Model Inputs |
|---|
Pier Cap
| FEM
| |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
End Bent
| Section Data
|
| ||||||||||||