Versions Compared

Version Old Version 24 New Version 25
Changes made by

Murat Bedel

Murat Bedel

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel
panelIconIdatlassian-info
panelIcon:info:
bgColor#DEEBFF

Follow the next steps to add the pier cap.

Copy-paste related data from model inputs. 14
1

Go to Pier Cap under Pier on the tree view

2

Click three-dots icon on the Location cell and select a support line

3

Click three-dots icon on the Section Data cell and click Edit

4

Enter Section Length along Y-Y starting from right

5

Select Start Section and End Section

6

Go back to pier cap, select Slope Option as alignment

7

Edit Top Elevation Offset from Alignment value

8

Go to FEM tab and select a section for Rigid Section

9

Follow the steps below to match the same inputs as illustrated model.

10

Go to Pier Cap under Pier on the tree view

1112
Expand
titleQuick Tip

Copy the desired data with the automatic copy button in the upper left corner.

Click on the first cell in and use the Ctrl+V shortcut to paste.

Image RemovedImage Removed

13
Image AddedImage Added

11

Go to Pier Cap under Pier on the tree view

12

Copy-paste related data from model inputs.

13

Go to FEM under Pier on the tree view

14

Copy-paste related data from model inputs.

15

Tip

     Completed pier cap is illustrated below

Pier Cap

Anchor
PierCap
PierCap

FEM

Anchor
FEM
FEM

End Bent

Code Block
PierCap1	Pier2	[[72, PierCapRec_Taper, PierCapRec_Mid],[438, PierCapRec_Mid, PierCapRec_Mid],[72, PierCapRec_Mid, PierCapRec_Taper]]	Alignment	N/A	-10	0
PierCap2	Pier3	[[72, PierCapRec_Taper, PierCapRec_Mid],[438, PierCapRec_Mid, PierCapRec_Mid],[72, PierCapRec_Mid, PierCapRec_Taper]]	Alignment	N/A	-10	0

Section Data

Code Block
6	PierCapRec_Taper	PierCapRec_Mid
36.5	PierCapRec_Mid	PierCapRec_Mid
6	PierCapRec_Mid	PierCapRec_Taper

INPUTS

Code Block
PierCap1	Yes	RigidSection	[0]
PierCap2	Yes	RigidSection	[0]