...
| 1 | Go to Roadway Alignment |  | ||||||||
| 2 | Enter Start Station as 0 | |||||||||
| 3 | Click the three-dots icon on the cell and Click Editor to define alignment properties |  | ||||||||
| 4 | Click icon next to the Horizontal and add a circular segment |  | ||||||||
| 5 | Enter Length as 530 ft, Radius as 700 ft, and Direction as Towards Right |  | ||||||||
| 6 |
|
| ||||||||
| 7 | Click icon next to the Transverse to define the alignment cross-section at a specific station |  | ||||||||
| 8 | Enter the cross-section Station as 0 ft | |||||||||
| 9 | Enter the Left Edge to PGL distance as 20 ft. This distance is the length from the left edge to the centerline of the alignment. |  | ||||||||
| 10 | Click icon next to the At Sta+0 and add a section component | |||||||||
| 11 | Enter the Width as 40 ft and Slope as %-5 |  | ||||||||
